Rigorous testing conducted by the U.S. Government and State Emissions Agencies confirms a break-through technology that dramatically reduces emissions, automotive pollution, saves gas and money.
Magnetizer's Engine Performance Maximizer (EPM) will astonish you by the way it increases combustion efficiency for a cleaner burning engine. Not only does the EPM reduce harmful emissions, but it increases engine performance. Designed for all cars and light trucks.
The strong magnetic charge the Engine Performance Maximizer puts into the fuel, air and coolant, gives your fuel a complete and clean burn so that you can take advantage of increased horsepower with reduced operating expenses. The EPM will dissolve existing corrosion and scale build-up in the head, cylinder cooling jackets, radiator and heater. No more costly repairs, plus your cooling system is operating at top efficiency.
Saving Gas With Magnets
In exchange for ten minutes of your mechanic's time, you are guaranteed a lifetime of protection and saving!
The EPM has no moving parts and is easily placed on the fuel line, water hose and air intake. It installs in minutes with no cutting or tools required. Simply strap it on! Beware of unscientifically designed inferior imitations. They have been shown to reduce mileage - not increase it. If you are not familiar with the internals of a car we recommend that you get a mechanic to install it for you. If you sell your car - take back your EPM and have it installed on your new vehicle. To use the Magnetizer EPM is arguably a moral obligation: Over 100 million tons of carbon monoxide are produced annually in the USA by engine emissions. Carbon monoxide is responsible for over 10% of the respiratory problems of the nation - including the increase of asthma in young children. The EPM reduces these emissions by an average of 83%.
Benefits
10 - 25% on average fuel savings - depending on age of engine
5 - 15% increase in horse power - high octane performance with lower octane fuel
50 - 95% reduction of Carbon Monoxide and Hydrocarbons
83% average reduction of hydrocarbons
Engine runs cleaner and therefore oil lasts longer
Improved performance - quicker starts and faster running
Maintains cooling system efficiency
Stops scale build up and corrosion in your engine
Reduces wear on oxygen sensor and Catalytic Converter
Healthier air and less smog for your community
Suitable for gasoline, diesel, cars and light trucks
Magnetizer's patented system has been sanctioned internationally as emission reduction equipment
Remember: If you are not familiar with the internals of a car we recommend that you get a mechanic to install it for you. If you sell your car - take back your EPM and have it installed on your new vehicle. Save on gas for the rest of your life!
Installation:
All magnetizer units are fitted externally around the fuel, air, and coolant lines. In the standard EPM kit, note the fuel and coolant magnets are secured with a back plate (steel plate, PVC coated); the air intake will employ 2 Magnetic pieces opposing each other - see attached photos. On vehicles equipped with multiple air intakes, the MAE-B (Magnetizer Air Energizer) should be fitted to both intakes. If space does not allow and there is a central point on the air intake prior to the location where it splits off to either side of the engine, this central point (before the split) is acceptable. On the fuel line, it is preferred to install the fuel unit as close to the point of combustion as possible on the main fuel line feeding the injectors....in some vehicles this will occur right before the injectors, in others it may actually be on the fuel line beneath the motor as the closest possible point. On the coolant line (radiator hose), placement can occur on the upper or lower radiator hose; in most cases the upper hose is easier to reach.
